Skip to main content

Reply to "build of 550 spyder"

I managed to find the wheels that I will be using. I will be using the steel rims from a renault megane. This is a 4 x 100 PCD which happens to match the front hubs for my disk brake conversion. The 5 x 100 rear hubs will be re-drilled to 4 x 100 pcd.

My question is as follows: How far out from the edge of the rim should the hubcap be. It is quite possible that for the front i might have to get the width of the rim adjusted for off set, perhaps with a spacer or changes to the rim.
×
×
×
×
×