Skip to main content

Reply to "Engine Cylinder head and Tranny contact temperature sensors"

Then I had to fabricate a bracket to install it under my dash and keep it mostly out of sight but the first hurdle was to change the wire output from the side of the unit and move it to the back of the unit so with the back cover off I proceeded to migrate the mass of wire to the back side or the unit then I sealed off the hole with JB  weld and since it was a tad grey I painted it flat black. 

Drill hole 

Moved to the back side and hole plugged not yet finished. 

Attachments

Images (3)
  • mceclip0
  • mceclip1
  • mceclip2
×
×
×
×
×