Skip to main content

Reply to "Front drum to disc conversion."

Measured on the back side, the thickness to the bearing is .515 on the thick side and .460 on the thin side. So the hub appears to be machined .055 off center.

Based on my experience as a machinist in another life I guessing they attached the disc to the hub, slapped it in the chuck, then machined the hub, rather than machining the hub, then attaching the disc and balancing it.

I wracking my brain to try an imagine a reality where this won’t result in horribly out of balance wheels/tires and a resultant vibration.  I hope you guys can before I call and raise hell tomorrow. 

Last edited by dlearl476
×
×
×
×
×