Early built CMC on 69 pan.
1. Where to get OEM cradle mounts or close too--I do not buy empi? Good used from Jack at Bug Stuff West Brownsville PA he has a three story old whse filled with good used and has a retail store too.
2. Which throw out bearing, disc, plate--have been out of shopping for many years. Sach brand is fine
3. Kafer bar or not. My left carb sits higher than the right by an inch+--could have twisted horns? Would I be able to over time get them straightened out or better to take it to a frame shop when trans is out? With the trans out and a guy that knows what he is doing heating things up...also be sure to check you don't have metal fatigue inside issues.
4. I have the round shroud with the straight forward outlets--no doghouse. My oil cooler mounted in wheel well is piped into a short stand on rear of block. Setrab cooler in well. Would like to drive in cooler weather--go with stock shroud? (which year?) ...I have seat heaters going in later. How would this effect how the cooler is set up now?? Do I need to repipe it? Learned how to braid lines when I did this 3 years ago--just a few nicks in the hands. Jack at Bug Stuff can advise you what he can provide for your set up. 724 785 7000 closed Mondays
Alan