Skip to main content

Reply to "Making Rubber Blocks"

Take what you've made, replace the plywood with a piece of 1" thick stall mat and I think you're done.  The 2X4 blocks will locate it, the flexibility will keep it from tipping up when it's rolled over, and they should slide out of the way easily once the front tires are past them.  The stall mat is robust enough to run screws through and with some RTV between the 2X4's and mat it should all stay together well.  You could taper the cuts on the mat for extra style points (and even though that your rig is loaded with style points a few more couldn't hurt).

A question; could whatever you make be slid toward the center of the car for storage once the front tires are past them, then slid back into position for unloading?

Last edited by JMM (Michael)
×
×
×
×
×