Skip to main content

For sale Freshly built turnkey 2276 Type 1 engine

 

For sale, a 2276 Type 1 turnkey engine including a new 1 5/8"  A-1 stainless steel sidewinder merged header and polished A1 muffler and dual outlet exhaust (which can be swapped out for center or side exit easily).  The dual 44 Weber carbs are brand new from CB Performance. The engine was built by Bill Westerfeld of Westerfeld Enterprises who has 40 years experience as a professional Porsche and VW race engine builder. The engine is ready to install and run.

Build specs are: 

Genuine VW ASA41full flowed case/welded #3 spigot

New 8mm ARP case studs

Close Fin Type 2 oil cooler

CB 8 dowel forged 12 lb. flywheel 

KEP stage 1 Pressure plate

solid center organic clutch

Mahle 94mm forged Piston and cylinders.  Total seal rings

82mm counter weighted and balanced crank with all new bearings

Porsche 912 rods.

All new main and rod bearings

55 amp Alternator

Welded fan

36hp style fan shroud

Engle FK43 cam

Scat lifters

New Flame Thrower 009 Distributor w/electronic ign. module

CB Taylor 8mm plug wires

CB 044 Ultra mag plus oval port heads 42mm intakes 37.5mm exhaust.

CB Port matched ultra mag welded intake manifolds.

1.4 ratio rockers on solid shafts/ hardened studs

Chrome molly Rods

New MST aluminum pulleys.

Aluminum vented valve covers

large deep sump 1.5 Qt. oil pan.

Fully dynamically balanced engine

9.5:1 CR  (94mm bore, 82mm stroke,.058" deck height, 55cc head chamber volume)

Engine is broken in and has 500 miles of road testing in my Puma to get carb jetting perfected. Carb jetting is .60 idle/ 150 main / 190 air correction

Engine does not leak oil.

Estimate engine is putting out in the 180hp range with the power band being 1800-6500 rpms

Engine idles smoothly at 850-900 rpms and starts easy and has been running oil temps of 185 average on 85-90 days without an auxiliary oil cooler which the engine is setup to run if you wish to add one. 

Price is $6500.00 / $5500.00 without the A1 exhaust.

I can crate the engine for shipping FOC. and extend my 65% trucking discount to the buyer. 

Feel free to call me: Jim Vickers 812-972-4516.  between 9am -9pm EST. 

Attachments

Images (6)
  • Puma 2276 finished engine rebuild new pulleys7-21-2020
  • Puma 2276 rear view 1
  • Puma 2110 to 2276 finished and installed
  • Puma 2110 to 2276 oil pan and header 1
  • Puma 2110 to 2276 rebuild 2
  • Puma 2110 to 2276 rebuild 6
Videos (1)
Puma 2276 Type 1 cam break in 7-17-2020
Last edited by Jimmy V.
Original Post
×
×
×
×
×