Project 48 was stripped of all externals, windshield, doors , deck lid, bonnet and bumpers. Pulled the seats, carpet, CMC gauges etc. Dash gauge holes and most other holes on the body were glassed in and all gaps to 3/16". Lowering the rear swing axle suspension a notch. Next up is the floors get coated with Chip Guard, body is amazingly smooth but will get a few guide coats and blocked then apply epoxy primer and block again followed by Porsche Seal Grey, color sanded and buff. In a couple of weeks I'll trailer from PA back home here to WV to complete the rest restoration.