Skip to main content

Reply to "Porsche Emblem install"

I used a die grinder to remove all the little studs and applied 3M emblem tape to the back of the emblems.  Then I used an Exacto knife to cut the tape to fit the emblems.  Next, peel the backing off the 3M tape and apply the emblem to the car.  Blue tape was used on the car to provide the exact locations of the emblems.   Alan makes a good point about the front emblem.  It will have to be gently bent to match the curve of the front of the car.  Note: test fit with the tape applied to the emblem before removing the backing.  The extra thickness of the tape may require the bend to be tweeked.

×
×
×
×
×