Skip to main content

Reply to "Rear Wheel rotor/bearings"

Purchased a used VS year ago on CT. While flat towing the speedster it started to sway quite a bit L & R and found the read drum was loose to the point I could turn the Castle nut with a vise grip. I cut some aluminum strips for shims from a aluminum soda can, set them in the drum spline opening and bending over the ends to make tabs. Sat on my butt kicking and forcing the drum on the axle shaft until it seated... Castle nut as tight as I could by pounding the vise crip with a rock and made the 250 trip back home.

×
×
×
×
×