Skip to main content

Reply to "Rounded Fan Hole"

The first thing I plan to do is slot the holes in the alternator stand close to the shroud and replace the studs on the other side with bolts.  Then, if Andrig's fan doesn't work out I can swap it without pulling the engine and shroud.

I always pull the studs and just put bolts in on all 4. If I'm having machine work done on the case, I have them put time-certs in, but for the rare times you're going to install and remove it - I think just threading into the magnesium or aluminum is fine.

Please report back to us your findings/thoughts. This is something I've been considering for a while.

Last edited by Stan Galat
×
×
×
×
×