Skip to main content

Reply to "Wheel Specs Needed"

George,

Please check my math on this. Assuiming the bolt circle has a diameter of 205mm (This from two different fairly reliable sources and confirmed by a fairly precise measurement), we locate a center on the aluminum stock and scribe a circle with a 102.5mm radius. On that circle we scribe 5 marks 72 degrees apart (360degrees/5 bolt holes). These five marks represent the center of the lug holes where we tap to take the bolts. Then we cut the center hole per shaft dimension taken from the wheel balance machine via mocrometer. Finally we cut the stock to fit inside the wheel and balance the whole thing so that when it is mounted on the balancer, the only thing getting balanced is the tire/wheel combo.

Does this make sense to you?
×
×
×
×
×