Skip to main content

Reply to "Wipers"

Don'r over think this. Pop off the plastic nut cover, 10mm nut gets removed, I gripped and ripped the old ww off the spline, use a round screwdriver to tilt out the small block on the new ww arm, line it up and tighten the bolt. If you want file a flat spot on the ww post spline before you put the new arm on. Make sure the blade portion is set back about a half inch from the end and tighten the blade to the arm. Turn on the ww and check for clearance.

I suppose if you don't like the way the arm sits proud of the body, which isn't much, you could file the post a little shorter so the arm sits lower. Just don't overdo it or the arm could contact the body.

×
×
×
×
×