Jimmmaay!
That's the exact info I needed. Thanks for putting it all in one place (again). The riser is the only section where I have a question (or two). Are we extending the riser up 10" or up to 10", so that when the bar is on the ground, the ball socket hitch part is 10" off the ground?
Oh, and I assume the 10" riser is predicated really on the height of the tow vehicle and the amount of 'drop' to the hitch on said vehicle? The end 'goal' is to have a flat (level) ball receiver when towing the speedster. Don't want it too put too much of angle on the ball hitch, etc.
Did you start with the EMPI bar and just make these mods? or did you start from scratch?
I wonder if the muffler shop in town would be willing to make these mods without too much grief? I really need to learn to weld, it would make my life a whole lot easier.
I'll add this to the list of 'to do' items before SLO. I still need to book a room! (ha!) Alexis (My lovely bride) said 'sounds like fun, so long as we can go wine tasting.' I will have to make that happen or I"ll be in trouble.
Thanks again for the info,
Ted