A short addendum to the wiper eyebrow saga, Ed (edsnova) cautioned me about the vulnerability of using Bondo where it isn't laying flat on the car. He also noted the possibility of the paint issues later. He suggested that I make reverse molds of the Bondo eyebrows and then fill the molds with finely chopped fiberglass (kitty fur) and resin. It felt like good counsel, so that is what I did and I'm happy with the way it turned out. Thanks, Ed!Bondo eyebrow w/resin shell
Facehugger attacks. I covered the eyebrow w/car was, stuck a tube in the wiper attachment hole and poured Bondo on top. 10 minutes later I had my mold (loosened it with a very thin paint scraper).
Mold after it popped loose. I then sanded off the eyebrows (again) with a longboard. Ed was right, they melted like butter.
Sunny side up eyebrows waiting for the kitty fur to cure. Got to keep them level :-)
Fiberglass eyebrow installed. It took a good bit of shaping to reduce the fiberglass piece back to the height of the original. I used a longboard with 80 grit and just kept at until it matched the empty spot on the hood.
Looks even better with a few coats of epoxy primer. More on that later.
Mike