Skip to main content

Reply to "Rhode Island Spyder Project"

My bearing caps finally came in on Friday.  They were holding up the installation of the rear brakes.  Raining day today , I wrapped up the installation of the rear brakes.  Getting it to roll is a nice milestone.  without a spare engine, transmission and set of tires hanging around my garage is started to have some open space.

I can use your20210425_153900 input on the setup the the emergency brake cables.  I thought I was being cleaver to remember to re-install the spring and washers that came with the EMPI kit before crimping the stop on the brake end of the cable.  Now it looks like the collapsed height of the spring is too long, prevents the E-brake from its full range of motion.  Do your E-brake cable setups have a spring around the cable at the brake end between the cable housing end and brake lever?     

Attachments

Images (1)
  • 20210425_153900
×
×
×
×
×