Skip to main content

There was an unexpected issue forwarding you to "Twitter" for authentication. Please try again later.
×

Reply to "Thunder Ranch build thread"

ED,

Yes, my SE/Beck does. You can see it carpet covered in one of the attached pic's. When I replaced my clutch cable and throttle cable and rubber fuel line this Summer to make it easy to do, I used a hole saw and cut an access hole in the top. Suggest you think about doing the same without it it's a challenge to attach a new clutch cable and throttle cable feed.

Mine also has a shallow U shaped steel channel from the fire wall to the dash area FG brace. It holds the fuel line, e-brake lines, one hard brake fluid line and steel clutch cable tube. You can see this channel and what's in it. The cable shifter tubes are routed I think about half way from the shifter exiting from the channel under each seat you can see those too. This entire channel has easy acces you just have to remove the Velcro leather. 

I changed the clutch cable through the std VW type access hole in my SE/Beck Speedster and it took a lot of contorting and time.  I didn't want to ever have to do that in the Spyder or the Speedster again without better access. Having an access hole in the Spyder should make this job pretty easy to do on the road in an emergency (I carry a spare of each cable in each car). Pete

IMG_0959IMG_0960IMG_0961). 

Pete

Attachments

Images (3)
  • IMG_0959
  • IMG_0960
  • IMG_0961
Last edited by mtflyr
×
×
×
×
×