Skip to main content

There was an unexpected issue forwarding you to "Twitter" for authentication. Please try again later.
×

Reply to "Thunder Ranch build thread"

Word on the web is that the Harbor Freight $100 (cheaper with coupon) planishing hammer is a very good tool. Apparently they stopped selling them about five years ago.

Nobody thinks their English Wheel is good for much. . . .

I may invest in their shrinker/stretcher and might just get a throatless shear from Eastwood or Woodward in the coming months, as the .050 alloy is just a little too much to cut with the snips (which anyway leave an edge that requires finishing attention.

Assuming (big word) I'm able to finish off this first half tonneau so that it looks like somebody cared, what do you all think might be a fair price for the part? I'd send them out bare with the rear pins made and located but not riveted in (to facilitate fitment); buyers would need to source their own front Tenax buttons according to what they wanted or had already on their dash.

Apparently there's a European supplier that gets about $1,000 US for the part.

I think I could  beat that.

×
×
×
×
×