Skip to main content

Classified postings do not allow for discussion (replies are not allowed).  Direct message the member if you would like to discuss the item.
The Classified section is open to any individual (non-commercial firms) posting of items for sale. Members posting commercial advertisements must be enrolled in a Supporting Merchant program. 
Postings without relevant details (PRICE, location, condition, etc.) will be deleted.

I made this stinger to improve the exhaust looks and be removable. It ain't cheap to make. All stainless and tig welded. Includes 2 gaskets. $100 and buyer pays shipping. Should fit in medium to large flat rate box.

Pipe is 3" and overall length with both flanges is approx. 10.5" installed. Kick-up angle will be approx. 14.5deg. Pipe can be cut shorter if needed once installed. Flange has a 3" to 2.5" adapter ring to fit typical A-1 exhaust. Brushed finish can be polished if desiredExhaust-001Exhaust-002Exhaust-003Exhaust-004Exhaust-005.

Basically remove existing stinger elbow, cut elbow near bend, weld on flange, reattach to header, bolt on new stinger.

Attachments

Images (5)
  • Exhaust-001
  • Exhaust-002
  • Exhaust-003
  • Exhaust-004
  • Exhaust-005
Original Post
Post Content
×
×
×
×
Link copied to your clipboard.
×
×