Skip to main content

Replies sorted oldest to newest

Here's steel parts from back of the CMC build manual:

F - front brace above H beam (not sure of H piece)

I - front hood bracket

G - rear bumper (rear lid looks similar but just flat where the angle iron piece is)

J - front bumper bracket  (need 4 2 1/2 U bolts too) and the individual pictured part

Gordon has paper templates for the engine sealing parts - or you can use card board and make them.  Mine are fiberglass but aluminum or duct tin can be used.

Attachments

Images (1)
  • mceclip0
Last edited by WOLFGANG

If you're looking for a photo of the heat shields between the hot (bottom) and cold-ish (top) of the engine compartment, this is from my build manual.  look in your kit to see if there is something similar (they're big).   If you don't find them, I have full-size paper templates that will help you make a pair out of HVAC sheet metal and they'll seal up the rear really well.  All I ask is postage $.

page2image928718768

Attachments

Images (1)
  • blobid0
Post Content
×
×
×
×
Link copied to your clipboard.
×
×