4 steel rims, 15 X 5.5”, with only about 100 miles. Took them off to put Vintage 190 alloys on. Silver powder coat, no scratches. CIP1 has them on sale now for $280 for a set of 4. I will sell for 1/2 price, $140 plus shipping. Frank 402-393-5252, fpcopo@cox.net. Thanks
Classified postings do not allow for discussion (replies are not allowed). Direct message the member if you would like to discuss the item.
The Classified section is open to any individual (non-commercial firms) posting of items for sale. Members posting commercial advertisements must be enrolled in a Supporting Merchant program.
Postings without relevant details (PRICE, location, condition, etc.) will be deleted.
Replies sorted oldest to newest
I was looking at making two of them 5" wide instead of 5.5". If I were to do this, making a 5.5 to 5 would be the way to go. I looked into a place that made blank rims, but the id on the 15" wheel they make is 12.4" and my centers come out to a little over 13". Damn. I'll have to make a call to a buddy machinist.
@Fpcopo VS would you just sell two of them??
Moving wheel centers is fairly easy for a machine shop. The weld bead lengths on the rim are measured, chuck the rim in the lathe place, lathe cuts the welds from the center to rim away, the center is moved into the new position , checked for run out with a dial indicator, tack welded and rechecked again for run out then the weld beads are done to the original lengths. I tried to do an old rim for the hell of it at my friend Rand's machine shop, it's an acquired skill and I was cursing left and right as Randy laughed :~)
Maybe if no one wants four I will sell 2.
Price lowered, $120 + shipping. If you have a Fastenal store nearby I can ship that way much cheaper.
Man....I would love them....but what would shipping be to 92115 San Diego?
@Mike373 posted:Man....I would love them....but what would shipping be to 92115 San Diego?
Others have used Greyhound or Fastenal with great success and great $$ savings. If either of those are near you it cold be an option.
Mike, tell me address of Fastenal store you want it sent to and I’ll figure out a price.
FpcopoVS That is very kind of you. Here is the nearest one: 4651 Mission Gorge Pl, San Diego, CA 92120 Would be shipping to 6555 El Cajon Blvd ...San Diego 92115
Thank you,
Mike
Fpcopo VS
I guess I should ask... Is the offset correct on these wheels to fit a JPS. The rear trailing arms have been chopped 1.5 inches. Also.....I am thinking about building a engine w 82 Stroke and 92 bore. How do you like your 2110? You can PM me if you like so I dont hijack this thread.
Sold. Mike, I sold my Speedster but the 2110 was a good all around engine. It never ran hot and was very driveable around town, even with the big 44 Weber’s that were on it.
So glad you found a buyer for the wheels. Were they local? Good to know about the engine. Was it an 82 stroke and 90.5 bore? What cam did you have in it?
Mike