Skip to main content

I'm taking the speedster to the alignment shop on Wednesday. I was planning on asking for the following setup but thought I'd see if anyone had any other suggestions. Many thanks! The proposed setup:

Front to rear leveled or rear up to 1" lower than front

- Front camber - 1.5 to 2 degrees negative

- Front toe in 1/8"

- 3/4" front sway bar

- Front caster 6-7 degrees

- Rear camber - 1.5 to 2 degrees negative

- Rear toe in 1/8"

- 3/4" rear sway bar

 

Mike Pickett

Original Post

Replies sorted oldest to newest

I run 1.5 degrees negative camber in the front, which is on the aggressive side for the street. You may(probably) won't be able to get that much unless you have the aftermarket camber adjusters that go in the top trailing arm where the ball joint bolt is.

I know general wisdom is 1/8" toe-in, but I've been using 1/16" front and rear for 15 years, and I really like it that way.

All your other settings are spot-on. Remember air pressure too, run 20-22 front and what, 25 or so in the back.

Agreed with Danny, for street driving you're front camber is a bit aggressive.  For street cars we set camber closer to zero in the front, err to the negative side with no more than 0.1 degree deviation left to right.  I usually target -0.2 to -0.3 degrees.

For toe that varies with how tight your suspension is, that is why you see such a range on adjustment... When your control arms defl3ct backwards under acceleration toe increases due to natural flex and/or any play in control arm bushings, etc...  If you can grab your front wheels and feel a slight amount of play left then be a little more aggressive on toe, like 1/8" total.  If they are uber tight you may want to dial that back to 1/16" or 1/32" total toe.

That's also a lot of caster.  VW spec is 3+/-1 and 356 spec is 5
Caster in a Beck is fixed and changes slightly as a result of camber change, but we're set up for 5 at stock ride height.

We run CRAZY amounts of caster in the track cars, 10-12 on GTS.  You lose straight line stability but the "snap back" and self correction of the wheel is a greater benefit to us...

 

Last edited by chines1

Boy, what a wealth of good information. Since I'm setting it up a regular street driver and not for racing, I'll apply the suggestions above and create a new target setup. Let me know if you think I've got it wrong. Thanks again!

Tire pressures: current 20 psi front / 28 psi rear 

Chassis level from front to rear

- Front camber 0.2 to 0.3 degrees negative

- Front toe in 1/6"

- Front caster 5-6 degrees

- 3/4" front sway bar

 

- Rear camber - 1.5 to 2 degrees negative

- Rear toe in 1/16"

- 3/4" rear sway bar

Michael B (aka bluespeedster SoCal) posted:
Gordon Nichols posted:

IIRC, at the last alignment I had my front caster set at 6 degrees.  It tracks really straight with zero bump steer but is a trifle harder to turn in parking lots.  

Gordon, youe 6-deg caster angle and tight turn issues must make parallel parking a nightmare?

A manly man has the forearms to be forewarned... or something.

Popeye-sailor-man-cartoon

I yam what I yam.

Attachments

Images (1)
  • Popeye-sailor-man-cartoon
Post Content
×
×
×
×
Link copied to your clipboard.
×
×