Skip to main content

Classified postings do not allow for discussion (replies are not allowed).  Direct message the member if you would like to discuss the item.
The Classified section is open to any individual (non-commercial firms) posting of items for sale. Members posting commercial advertisements must be enrolled in a Supporting Merchant program. 
Postings without relevant details (PRICE, location, condition, etc.) will be deleted.

Hand-shaped 16 gauge (.050) 5052 aluminum, $750 plus shipping.

IMG_E7177

Comes unfinished, blocked to 400 grit, ready for paint, with installation/mounting instructions and two pins on steel plates pre-drilled for rear mounts. Front mounting is up to you.

IMG_E7139

These should fit all Beck, Vintage, Thunder Ranch and similar 550 replicas based off Chuck Beck's original molds. No good for CMI, original Spyders or Spyder Factory, 502 Moterworks etc.

IMG_E7149

If you contact me with measurements I will make it to length so you can use your existing tonneau studs in the front. Otherwise it will likely come short of those, and you'll need to install new Tenax studs or nut-certs for thumbscrew mounts.

IMG_E7157IMG_E7160

These are made to look and work like the original item. Pictured here is the first one I've made; I've adjusted the buck to make subsequent ones fit better.

IMG_E7165IMG_E7166

I am planning to make a few over the next several weeks. Order soon and have it installed for the 2021 spring season.

Attachments

Images (8)
  • IMG_E7149
  • IMG_E7139
  • IMG_E7149
  • IMG_E7157
  • IMG_E7160
  • IMG_E7165
  • IMG_E7166
  • IMG_E7177
Last edited by edsnova
Original Post

Replies sorted oldest to newest

Post Content
×
×
×
×
Link copied to your clipboard.
×
×