Skip to main content

I don't think Carey has engine cruise for it yet, but I'm not a big user of cruise control anyway.

Well , it is much easier than any cruise install as it is already in the ECU, so with a few switches on the brake and clutch and a few toggle switches, two idiot lights for confirmation, you can get throttle assist on the longer highway cruises,  like 8 hours for me to Carlisle.  Works like a charm and prevents you from getting your picture taken when your half asleep behind the wheel and you look down and your doing 90mph instead of your normal 70mph because the car was running so good

My brothers and I knew an Italian kid that came to school at BYU. Max. He quit school and opened a foreign car service after working a couple of years at one of the VW shops. Good plan. For years he was the only guy in town.

He had an 850 Spider with a 124 engine in it. Used to Auto-X it at the local Gymkana. He also bought a Fiat Dino with a blown head gasket for $1500. That thing was beautiful.  This same color.
3A2A7FD8-3330-4B7D-BB2F-49CB35D47121

Attachments

Images (1)
  • 3A2A7FD8-3330-4B7D-BB2F-49CB35D47121
Last edited by dlearl476

Ok, just finished raising the ride height about 1/2" to give me some clearance at the air scoop.  Soooo easy with coil-overs!  The hardest part was getting the C-type hubcaps off.  Next week I'll be working with a friend more skilled than me to reshape it.  Found a "heat leak" in the front fire wall allowing some of the radiator exhaust air to enter the cabin and roast you a bit in the Charleston heat.  We'll address that as well.  I hereby declare the SC lowcountry to be the hot climate testing site for Beck.

This beta testing is kind of fun, and future cars will benefit from any things I find.

Last edited by Lane Anderson

Is the bottom of the radiator housed in the projection/rectangle box located below the lower part of the front bumper? Why can't they raise the radiator up a little so that the bottom is even with the line of the bottom of the lower bumper and then cut vertical slots in the lower part of front bumper to make a grill for air flow? It would look much cleaner and look like the rear grill I have seen covering the muffler on some 356's.

Something like this:

IMG_E5682

D2875547-0AB4-400E-BC3B-1C8AA346371D

Joel

Last edited by Joel Roth
@DannyP posted:

And all three snips, left, right, and straight.

You can easily get by without the yellow ones.

@dlearl476 posted:

Brake

... to go with the red and green aviation snips

I don't think Carey has engine cruise for it yet, but I'm not a big user of cruise control anyway.

Your interstate highways are clearly not boring enough, Lane.

More strenuous testing will be required. Please report to Brevard, NC in late September.

it was designed by Bertone and looked sharp so I guess it was worth it - At least to her.   Fiat’s next Bertone car was the X1/9 (I think both were designed by the same dude from Ferrari)

I never could figure out how the Bertone thing got traction (back in the day) when Pininfarina was right across town kicking out drop-dead gorgeous shapes. I always thought Bertones looked... odd.

@Stan Galat posted:

You can easily get by without the yellow ones.

I never could figure out how the Bertone thing got traction (back in the day) when Pininfarina was right across town kicking out drop-dead gorgeous shapes. I always thought Bertones looked... odd.

I only have the yellow snips...

Porsche(and VW) used many coachbuilders, why not Fiat? I actually like the X1/9, but yes Pininfarina made beautiful things.

Wendler, Reutter, Karmann, Wiedenhausen, and Weinsburg were some.

@DannyP - yeah, I know all about the Carrozzeria. I was just never very wild about any Bertone design.

The Pininfarina Fiat 1600 cabriolet is almost as beautiful as the Ferrari 550 (also designed by Pininfarina). My point is that nearly every Pininfarina Ferrari (and Fiat, etc.) was drop-dead gorgeous. The Bertone designs were... "of a time", to put it nicely.

PS: Do yourself a favor - buy a pair each of Wiss red and green aviator snips with the angled heads. It'll change your life.

Last edited by Stan Galat
@Stan Galat posted:

I never could figure out how the Bertone thing got traction (back in the day) when Pininfarina was right across town kicking out drop-dead gorgeous shapes. I always thought Bertones looked... odd.

Across the board, with a few exceptions, Bertone designed coupes and sedans and Pininfarina designed convertibles. Even in the same manufacture/platform. ie Fiat 124 sedan/Spider, Alfa Alfetta*/GTV6-Spider etc.

Imo, Bertone’s designed for Aston are some of their most beautiful cars ever.


*IIRC, the Alfetta was Guigiaro’s  first design after he left Bertone.

Last edited by dlearl476
@Joel Roth posted:

Is the bottom of the radiator housed in the projection/rectangle box located below the lower part of the front bumper? Why can't they raise the radiator up a little so that the bottom is even with the line of the bottom of the lower bumper and then cut vertical slots in the lower part of front bumper to make a grill for air flow? It would look much cleaner and look like the rear grill I have seen covering the muffler on some 356's.

Something like this:

IMG_E5682

D2875547-0AB4-400E-BC3B-1C8AA346371D

Joel

Not currently.  The air scoop is the box under the front of the car.  The radiator doesn't extend below the car anyway, but is inclined at a shallow angle with the base even with the bottom of the car.  Room is somewhat limited by the gas tank, A/C condenser, and other plumbing.  The scoop is angled upward to force air through the radiator with a ram effect, which it appears to do well.  What I hope to do is go with a wider scoop that doesn't extend so low, and probably use some ducting incorporate the two large openings on each side.  That will keep or increase the area of the opening while not being as low.  I agree that a grill of some sort under the bumper would be advantageous and probably affect the appearance minimally.  I'll discuss that with Carey.  I am already up in clearance more than some modern Porsches, so I think we're moving in the right direction (pun intended ).

I want to make sure that everyone understands that this is kind of what I signed up for.  A little "sweat equity" is how I can afford this.  Carey and the team have done a stellar job, but there are things that simply take a lot of real-world use in a variety of conditions to resolve, and I knew that going in.  I consider myself part of the team.

Last edited by Lane Anderson

I want to make sure that everyone understands that this is kind of what I signed up for.  A little "sweat equity" is how I can afford this.  Carey and the team have done a stellar job, but there are things that simply take a lot of real-world use in a variety of conditions to resolve, and I knew that going in.  I consider myself part of the team.



Well, that is a given with version one, you will be part of the experiment and fine tuning of the car and it can take a few years for all issues to come to fruition.  

Here's hoping that nothing major happens and the small stuff all works out for you in the end Lane.

I liked the Giugiaro-designed Isuzu Impulse I had.

That was supposed to be the Scirocco III, but VW decided not to build it. GG then sold it to Isuzu, changed the lines a bit because it was front engine/longitudinal/RWD.

I don't know who designed the Corrado(Scirocco replacement) but mine was built by Karmann. I owned a 1977 Scirocco I, a 1987 Scirocco 16v, and a G60 Corrado. I loved all three. They were all great, but my VERY modified Corrado was the most fun, 98,000 miles in 8 years from new in 1990.

I have to share with y'all (a southerism meaning "all of you" ) some of the response I've gotten to this car at the four car shows (Carlisle, two local Cars & Coffee, local Ale and Octane) I've attended so far.  The reception has been amazing. @chines1, I hope you realize the hit you have with this car.  I've had elderly folk (meaning slightly older than me) who owned 356s back in the day, current Porsche owners, and pretty much everyone else tell me that it's one of the most beautiful cars they've ever seen.  They are amazed at how it looks, how it captures the best of the 356, and how it includes modern engineering.  I'll take some credit for the color and design choices as apparently everybody loves Oslo blue with cognac leather, but the overall theme has really hit the target.  Carey, please let Chuck know just how on target this is. It's interesting how many people recognize the Beck name.

I posted some pictures yesterday on an international Speedster/Coupe replica site and already have nearly 450 likes and nearly 90 comments.  I have a friend (Jim) who has built high end hot rods and even an aluminum bodied sports car that is a cross between an Aston Martin DB3S and a late 50s Ferrari sports racer.  He fell in love and tells me he wants one.  He's also offered his time and his shop to help me with the final sorting.  A mutual friend told me that Jim told him that my car was "f*cking gorgeous!"  That is high praise from someone who builds six-figure passion-mobiles.

I'm not saying this to brag.  Instead I want to express how lucky I feel I am.  It was a long wait and I almost bailed at a couple of points, but it was worth it.  This has been a fun, occasionally frustrating, but ultimately rewarding adventure.

I've got some sorting to do, which will make me feel more involved/invested in the whole project, which is important to me.  I think most of us on this site want to have a personal investment in the car, otherwise it's just a car, regardless of how well it performs.

Happy 4th, y'all!

Last edited by Lane Anderson
Post Content
×
×
×
×
Link copied to your clipboard.
×
×