Skip to main content

Finally had a chance to test drive the car after replacing all oil lines and installed AN fittings. I noticed oil on the ground after parking the car and found a hose failure.

This is PRO Flow 350 hose from JEGS and rated at 350PSI and 350 degrees. The hose actually collapsed once I pulled the heat shielding that I had over the hose I could finally see the leak.

I'll the video on facebook as its won't upload here even within the file parameters.

Original Post

Replies sorted oldest to newest

Update on the oil line failure. I removed the line, cut out the affected section and put the boroscope inside and found the line had split internally. The hose is rubber with wire reinforcement and nylon lined.

I believe what happened was that when tightening the connection to the oil pump the line twisted and because I had a heat sleeve over it I did not see it. So it would seem that the spec in turn of radius for the hose is ok but any torsion along the longitudinal  of the hose is a problem.

Attachments

Images (2)
  • IMG_0231
  • IMG_0232
Post Content
×
×
×
×
Link copied to your clipboard.
×
×