Skip to main content

I get a loud hard metal on metal clunk from the rear when hitting a dip in the road at speed. I have checked the muffler, exhaust and oil sump they have no sign damage so I think it is the one or both spring plates hitting either the top or bottom metal lips or stops built into the torsion tube arms. Since I have the rubber bumpers on top of the axle hubs I don't think it is bottoming out (hitting the top lip). I switched from swing axle to IRS but kept the same shocks. Not sure if they use different shock lengths? Also I have the rear height set about 3/4" above the rim. Any ideas?IMG_0300

Attachments

Images (1)
  • IMG_0300
Original Post

Replies sorted oldest to newest

.

We ('we' in the editorial sense) clearanced the frame.

Tony then made up a small brace and welded that back in place so no strength would be lost. It was the cowboy thing to do.

Of course, about a year later, we (again, in the editorial sense) ended up raising the rear ride height quite a bit when I tired of leaving small pieces of my sump scattered on picturesque rural roads throughout Amador county. That, by itself, would have solved the clearance problem, but these cars are all about acquiring knowledge slowly, in stages, and in the most expensive way possible.

.

Thanks Mitch. Even though I swapped the left and right calipers so the ebrake spring is on the bottom, sure enough you were right. The caliper body on passenger side is hitting the frame rail even though there is 2 1/4"clearance without passengers . Funny thing is the rubber bumpers are almost touching the bump stop on the upper shock mounts. Didn't think they would compress that much to allow the caliper to hit. Also no wonder the rear suspension is harsh the shocks are doing nothing on compression.

Well This is my first attempt at keeping the the rear brake calipers from hitting the engine frame rails without raising the rear end. 26mm torsion bars. 4mm thicker than stock. I am sure it will give it a rough ride but the car was already sitting on the rubber bump stops so how much worse can it be! I am about to find out. Cutting or removing the bump stops would not have worked because even with them installed the rear still compressed enough to hit the caliper body.  If the new torsion bars don't limit the travel enough then back to square one. I did order compression adjustable Konis but they are on back order and these arrived first.

I had to cut a hole in the body to get the old one out but fortunately when my dad and I put the car together back in 2000 he decided to fill the fake torsion bar hole ring and move the body molding back to center it between the tires. That gave me enough space to get the bar out and still have the molding cover the hole. Just have to use a fender washer behind the body for the last screw to keep it tight.

IMG_0304IMG_0305IMG_0306

Attachments

Images (3)
  • IMG_0304
  • IMG_0305
  • IMG_0306

Well This is my first attempt at keeping the the rear brake calipers from hitting the engine frame rails without raising the rear end.

Is it the caliper itself hitting the frame, or the brake line connection? I ask, because I had to put banjo fittings on my rear brake lines to get them to clear. I forget where I got them, but I could find the (10 year old) receipt if pressed.

Post Content
×
×
×
×
Link copied to your clipboard.
×
×